VLAN - ICT Fella

How to – Juniper EX/QFX Layer 3 Switch Configuration

This post is to list the basic configuration for the Juniper EX/QFX Layer3 switch. Similar to the previous Cisco Layer 3 configuration, it will demonstrate the most used configurations based on the production deployments. Related Topic: How to – Juniper EX switch Virtual Chassis and JUNOS upgrade https://ictfella.com/juniper-ex-switch-virtual-chassis-stacking-and-junos-upgrade/ How to Configure Cisco Layer 3 Switch […]

How to – Juniper EX/QFX Layer 3 Switch Configuration Read More »

How to Configure Cisco Layer 3 Switch

Routing and Switching

This post is to list out the basic configuration on a Cisco Layer 3 Switch, if you are configuring a Layer 2 Switch, you can simply remove the additional SVIs except for the switch management VLAN. Host Name and Enable Password Encryption Enable 3rd Party SFP Module Support Domain and DNS Configuraiton Enable Link Layer

How to Configure Cisco Layer 3 Switch Read More »

AirMax GigaBeam – How to Configure VLAN Trunking

Routing and Switching, Wireless

This post is to demonstrate the process to configure VLAN Trunking with Ubiquiti AirMax GigaBeam Point to Point device. Unlike Ubiquiti Nano stations, those AirMax GigaBeam (GBE-LR) does NOT need to configure VLANs or Bridge etc for the trunk port to work. If you want to check VLAN Trunking configuration with Nanostation devices, see below

AirMax GigaBeam – How to Configure VLAN Trunking Read More »

How to Configure Nutanix VMware Cluster Field Installation – Part 4

Nutanix HCI

Object This serial of posts is to demonstrate the Nutanix VMware Cluster Field Installation process with step-by-step procedures. Part 4 is for the Nutanix Cluster network and storage configuration. Clarification Nutanix Cluster forms the “Storage” using the disks across all ESXi nodes in the cluster, it is achieved by Controller VM (CVM) and presented as

How to Configure Nutanix VMware Cluster Field Installation – Part 4 Read More »

Ubiquiti Nanostation – How to Configure VLAN Trunking

Routing and Switching, Wireless

Object This post is to show you the way to configure VLANs on Ubiquiti Nanostation and demonstrate how to trunk the VLANs using over Point to Point Wireless. Ubiquiti Nanastations are very commonly used by customers when it is not feasible to connect two locations via fibre or the physical distance is over 100M for

Ubiquiti Nanostation – How to Configure VLAN Trunking Read More »

How to Rewrite VLAN Number on Juniper EX

Routing and Switching

Object Juniper VLAN Number Rewrite is very useful when you are executing a network transition project, scenarios can be you are trying to use the same subnets on both new and old environments, or the ISP gives you a VLAN number that overlaps your VLAN number in your current network. Solution The below example shows

How to Rewrite VLAN Number on Juniper EX Read More »